Congratulations on your purchase of the Echidna Hooping Station! Your hooping experience will never be the same!
This article will run down how you can set up your hooping station with only a screwdriver so you can begin hooping the easy way.

Here are two videos showing you how to set up both your large & small Echidna Hooping Stations. Written instructions are provided below as well:

Large Echidna Hooping Station:

Small Echidna Hooping Station:

Step 1: Remove all contents from the box.

To begin setting up your Echidna Hooping Station(s), I recommend taking all contents out of the box and organizing them for an easier setup. As you can see I made groups of the contents and laid them across the table. After removing everything from out of the box you should have the following:

  • Instruction manual
  • twist locks
  • pins
  • 2 panels
  • magnets
  • 2 legs

Step 1

Step 2: Placing Your Pins

Next, we’re simply going to insert our pins into the panels. First, tighten them with your hands then make sure you grab your screwdriver to ensure they’re all completely screwed in.

Step 2

Step 3: Inserting Your Twist Locks:

Now we’re going to insert our twist locks. A quick reminder: make sure the arrow on your twist lock is facing towards the hole on either side of the legs.

Step 3Step 4

Step 4: Assembly:

Finally, we’re going to take our leg and line the holes on it up to the pins on our panels. Next simply tighten your twist locks, flip it over and repeat the process.

Step 5Step 7

Step 5: Start Hooping!

Once your panels are securely tightened to your leg, simply place your magnets on the board and start hooping the easy way! Have fun and enjoy your brand new Echidna Hooping Station(s)!

echidna hooping station

Hope this helped! If you haven’t gotten your Echidna Hooping Station yet be sure to click here to place your order now! Hurry as supplies are limited.